LEGRAND Raritan PX3TS User Manual page 166

Chapter 6: Using the PX3TS
146
3. If your PX3TS is a PX3TS-5000 model, it supports the active energy pulse
output. Press
By default the energy pulsing is turned off. DO NOT enable this feature
unless you have to use it.
Note: This feature, once enabled, blink all outlet LEDs proportional to the
energy consumption. It can be used as a simple interface in certification
labs where they use an optical sensor to count the number of pulses and
compare it to the energy reading of a reference meter.
a. To change the energy pulse settings, press
b. Press or
c. Press to confirm the selection, or
Note: All outlet LEDs on the PX3TS turn OFF after enabling the energy
pulsing. You still can turn on or off outlets during the pulsing period though
outlet LEDs do not change their status.
4. Press to show the following data:
▪
Information of total active power (W) and total active energy (Wh).
▪
Status of the 12V power supply to the controller. For details on the
sensors, see PDU
5. To return to the Main Menu, press
Transfer Switch
The "Transfer Switch" pages show both the transfer switch- and inlets-related
data, which is separated into two or three pages. Page numbers are indicated
in the top-right corner of the LCD display.
To show the transfer switch information:
1. Press or
press .
to enter the Energy Pulse page.
to select an option.
(on page 206).
.
to select "Transfer Switch" in the Main Menu, and
.
to cancel.