Change Parameter Settings With Pc And Lenze Software - Lenze E84AVSC Operating Instructions Manual

5.2.2

Change parameter settings with PC and Lenze software

The USB diagnostic adapter, for instance, can be used for the communication between the
PC (including the L-force »EASY Starter« or L-force »Engineer« software) and the controller,
see illustration. The USB diagnostic adapter is the connection between the PC (free USB
port) and the controller (diagnostic interface X6).
[5-2] Exemplary constellation for parameterising the controller
The All parameters tab in the »EASY Starter« and the »Engineer« provides a quick access to
all parameters of the controller.
The given categories () and subcategories () correspond 1:1 to the menus and
submenus of the keypad:
[5-3] All parameters tab in the L-force »EASY Starter«
Moreover, the »Engineer« provides a commissioning interface on the Application
parameters tab where you can commission the application in a few steps.

Detailed information on how to handle the »Engineer« can be found in the
integrated online help that you can call with the [F1] function key.
from Firmware V06.00 - DMS 1.1 EN - 11/2011
8400 StateLine C | Operating instructions
L
Before commissioning
General notes on parameters
19