Frame-Relay Policy - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

frame-relay policy

Syntax
Release Information
Description
Options
Mode
Related
Documentation
650
frame-relay policy { input | output } policyName
[ statistics { enabled [ baseline { enabled | disabled } ] [ preserve | merge ] |
disabled [ merge ] } | merge ]
no frame-relay policy { input | output } [ policyName ]
Command introduced before JunosE Release 7.1.0.
merge keyword added in JunosE Release 7.2.0.
Assigns a policy list to the ingress or egress of a Frame Relay interface. If you enter this
command when the policy list does not exist, the router will create a policy list with a
filter rule as the default. You must specify the input or output keyword to assign the
policy list to the ingress or egress of the interface. The no version removes the association
between a policy list and an interface.
input—Applies policy to data arriving at this interface
output—Applies policy to data leaving this interface
policyName—Name of the policy; a maximum of 40 characters
statistics—Enables or disable collection of policy routing statistics
enabled—Enables collection of policy routing statistics
baseline enabled—Enables baselining of policy routing statistics
baseline disabled—Disables baselining of policy routing statistics
preserve—Preserves existing statistics for any classifier-list that is the same for both
the new and old policy attachments when you attach a new policy to an interface
disabled—Disables collection of policy routing statistics
merge—Enables merging of multiple policies to form a single policy
Interface Configuration
Setting a Statistics Baseline for Policies
Copyright © 2010, Juniper Networks, Inc.