Related
Documentation
Creating or Modifying Classifier Control Lists for ATM Policy Lists
Related
Documentation
Creating or Modifying Classifier Control Lists for Frame-Relay Policy Lists
Copyright © 2010, Juniper Networks, Inc.
Table 3: CLACL Criteria (continued)
Type of CLACL
Criteria
MPLS
Color
Mark experimental (EXP) bit
Traffic class
User packet class
VLAN
Color
Traffic class
User packet class
User priority
You configure CLACLs with a name and then values to match in the IP datagram header.
A CLACL does not include an action: actions take place when a match is included in a
policy list.
NOTE: Do not use the asterisk (*) for the name of a classifier list. The asterisk
is used as a wildcard for the classifier-group command.
If you do not specify one of the frame-relay, gre-tunnel, ip, ipv6, l2tp, mpls,
or vlan keywords, the router creates an IP classifier list. This version of the
command has been deprecated and may be removed in a future release.
For information about the hardware and software CLACLs that are supported for each
interface type, see Policy Resources Overview on page 151.
For information about monitoring Classifier Lists, see Monitoring Policy Management
Overview on page 173.
You can create or modify a classifier control list that can be used only in ATM policy lists.
Issue the atm classifier-list command:
host1(config)#atm classifier-list atmclassifier color red user-packet-class 10
clp 1
atm classifier-list
You can create or modify a classifier control list that can be used only in Frame Relay
policy lists.
Issue the frame-relay classifier-list command.;
Chapter 2: Creating Classifier Control Lists for Policies
9