Atm Policy - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

atm policy

atm policy { input | output } policyName
Syntax
[ statistics { enabled [ preserve | merge ] | disabled [ merge ] } | merge ]
no atm policy { input | output } [ policyName ]
Command introduced in JUNOSe Release 7.1.0.
Release Information
merge keyword added in JUNOSe Release 7.2.0.
Assigns a policy list to the ingress or egress of an ATM interface. If you enter this
Description
command when the policy list does not exist, the router creates a policy list with a
filter rule as the default. You must specify the input or output keyword to assign the
policy list to the ingress or egress of the interface. The no version removes the
association between a policy list and an interface.
Options
Interface Configuration
Mode
Related Topics
180
atm policy
input Applies policy to data arriving at this interface
output Applies policy to data leaving this interface
policyName Name of the policy; a maximum of 40 characters
statistics Enables or disables collection of policy routing statistics
enabled Enables collection of policy routing statistics
preserve Preserves existing statistics for any classifier-list that is the same
for both the new and old policy attachments when you attach a new policy
to an interface
disabled Disables collection of policy routing statistics
merge Enables merging of multiple policies to form a single policy
Setting a Statistics Baseline for Policies