Pim Timer Hello; Pim Timer Graft-Retry - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
By default, the state refresh feature is enabled.
Related
state-refresh-ttl.
Examples
# Disable state refresh on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim state-refresh-capable

4.1.46 pim timer graft-retry

Syntax
pim timer graft-retry interval
undo pim timer graft-retry
View
Interface view
Parameters
interval: Graft retry period in seconds, with an effective range of 1 to 65,535.
Description
Use the pim timer graft-retry command to configure the graft retry period.
Use the undo pim timer graft-retry command to restore the system default.
By default, the graft retry period is 3 seconds.
Examples
# Set the graft retry period to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer graft-retry 80

4.1.47 pim timer hello

Syntax
pim timer hello interval
undo pim timer hello
commands: state-refresh-interval,
4-42
Chapter 4 PIM Configuration Commands
state-refresh-rate-limit,