Reset Pim Routing-Table; Spt-Switch-Threshold - H3C s3600 series Command Manual

<Sysname> reset pim neighbor 25.5.4.3

reset pim routing-table

Syntax
reset pim routing-table { all | { group-address [ mask { mask-length | mask } ] | source-address [ mask
{ mask-length | mask } ] | incoming-interface interface-type interface-number } * }
View
User view
Parameters
all: Clears all PIM routing entries.
group-address: Multicast group address in the range of 224.0.0.0 to 239.255.255.255.
source-address: Multicast source address.
mask: Mask of the multicast group address or multicast source address, 255.255.255.255 by default.
mask-length: Mask length of the multicast group address or multicast source address, in the range of 0
to 32. The system default is 32.
incoming-interface: Specifies the incoming interface. With this keyword provided, the command clears
the PIM routing entries of which the incoming interface is the specified one.
interface-type interface-number: Specifies an interface by its type and number. If you specify null, the
command clears the multicast routing entries without an incoming interface.
Description
Use the reset pim routing-table command to clear PIM route entries.
You can provide a source address before or after a group address in the command, as long as they are
valid. An error message will be given if you type an invalid address.
In this command, if the group-address is 224.0.0.0/24 and source-address is the RP address (where
group address can have a mask, but the resulted IP address must be 224.0.0.0, and source address
has no mask), then it means only the (*, *, RP) entry will be cleared.
In this command, if the group-address is a group address, and source-address is 0 (where group
address can have a mask and source address has no mask), then only the (*, G) entry will be cleared.
This command shall clear not only multicast route entries from PIM routing table, but also the
corresponding route entries and forward entries in the multicast core routing table and MFC.
Related commands: reset multicast routing-table, reset multicast forwarding-table, display pim
routing-table.
Examples
# Clear the route entries with the group address of 225.5.4.3 from the PIM routing table.
<Sysname> reset pim routing-table 225.5.4.3

spt-switch-threshold

Syntax
spt-switch-threshold infinity [ group-policy acl-number [ order order-value ] ]
3-15