Mac-Address (System View) - H3C S5120-SI Series Command Reference Manual

Related commands: display mac-address.
Examples
# Add a static entry for MAC address 000f-e201-0101 on port GigabitEthernet1/0/1 that belongs to
VLAN 2.
<Sysname> system-view
[Sysname] interface GigabitEthernet1/0/1
[Sysname- GigabitEthernet1/0/1] mac-address static 000f-e201-0101 vlan 2
# Add a static entry for MAC address 000f-e201-0102 on port Bridge-Aggregation 1 that belongs to
VLAN 1.
<Sysname> system-view
[Sysname] interface bridge-Aggregation 1
[Sysname-Bridge-Aggregation1] mac-address static 000f-e201-0102 vlan 1

mac-address (system view)

Syntax
mac-address blackhole mac-address vlan vlan-id
mac-address { dynamic | static } mac-address interface interface-type interface-number vlan vlan-id
undo mac-address [ { dynamic | static } mac-address interface interface-type interface-number vlan
vlan-id ]
undo mac-address [ blackhole | dynamic | static ] [ mac-address ] vlan vlan-id
undo mac-address [ dynamic | static ] mac-address interface interface-type interface-number vlan
vlan-id
undo mac-address [ dynamic | static ] interface interface-type interface-number
View
System view
Default Level
2: System level
Parameters
blackhole: Destination blackhole MAC address entries. These entries do not age but you can add
or remove them. The packets whose destination MAC addresses match destination blackhole MAC
address entries are dropped.
mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted; for example, inputting "f-e2-1" indicates that the MAC address
is "000f-00e2-0001".
vlan vlan-id: Specifies an existing VLAN to which the Ethernet interface belongs, where vlan-id is the
specified VLAN ID, in the range 1 to 4094.
dynamic: Dynamic MAC address entries. Aging time is set for these entries.
static: Static MAC address entries. These entries do not age but you can add or remove them.
1-5