Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Total Nets
Intra Area
Inter Area
ASE
NSSA
3.1.23 display ospf vlink
Syntax
display ospf [ process-id ] vlink
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf vlink command to display OSPF virtual link information.
If no OSPF process is specified, the OSPF virtual link information of all OSPF
processes is displayed.
Examples
# Display OSPF virtual link information.
<Sysname> display ospf vlink
Virtual-link Neighbor-ID
Interface: 10.1.2.1 (Vlan-interface1)
Cost: 1
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Field
Total networks
Total intra-area routes
Total inter-area routes
Total ASE routes
Total NSSA routes
OSPF Process 1 with Router ID 3.3.3.3
Virtual Links
State: P-2-P
Type: Virtual
Chapter 3 OSPF Configuration Commands
Description
-> 2.2.2.2, Neighbor-State: Full
3-30