Table of Contents
Advertisement
LMBR-650
For networking and
managing rooms,
floors, and building
(not needed for
stand-alone rooms)
LMRC-611MCC
LMSW-611-S
Wireless
Slim Switch
Sensor Params
LMPX-600
LMPC-600
Mode
Blink
Load Type Dim
DLM Configuration App
on a mobile device
HYBRID ROOM CONNECTION WITH WIRED LIGHTING CONTROL AND DLM SHADING
LMSW-622-S
Controller
Wireless
(LMRC-112)
Slim Switch
LMBC-650
Wireless
Network Bridge
Ceiling Mount
Sensor
To ensure a successful installation and startup of a wireless system, the following steps must be taken by the
installing contractor. Failure to document all device address and locations may delay completion of startup
and result in additional startup charges.
Key Requirement: Document every Device's MAC Address (at least the last 4 alphanumeric characters). An
additional MAC address label is included for the installer to use on a floor plan map. The last four characters are
repeated in a larger font, in bold. Keep this document so that the commissioning tech has access at a later date.
WIRELESS ROOM CONNECTION
IPv6 Mesh for
networking of DLM
rooms and devices
over 6LoWPAN
Bluetooth low energy
communication for
mobile App support
Wireless
Sensor and/or
Photosensor
Auto On
On
Line
Voltage
Room
Line Voltage
Class 1 Dimming
(Class 2 also available)
LMBR-650
Border Router
IMPORTANT INSTALLATION INFORMATION
Distance Recommendations:
60' max between LMSW-6xx-S and mobile device
60' max. between LMSW-6xx-S and room
controller or bridge
10' minimum and 100' maximum between LMBR-
650 and room controller or bridge
Load
Examples
any relay)
(
Switched
A
etc.
Switched with
B
B
0-10 Volt control
Dimming Ballast
LED Driver, etc.
Sensor Params
LMPX-600
LMPC-600
Mode
Auto On
Blink
On
Load Type Dim
DLM Configuration App
on a mobile device
Note: the DLM config app
can only connect with the
LMBC-650 to update firwmare.
You need an LMBR-650 and
LMCS to commision a Hybrid
room.
3
Examples of labels
Advertisement
Table of Contents
