Chapter 1 Nat Configuration Commands; Nat Configuration Commands; Display Nat Address-Group; Display Nat Aging-Time - H3C S9500 Series Command Manual

Command Manual – NAT
H3C S9500 Series Routing Switches

Chapter 1 NAT Configuration Commands

Note:
The line processing units (LPU) mentioned in this chapter refer to LSB1NATB0.

1.1 NAT Configuration Commands

1.1.1 display nat address-group

Syntax
display nat address-group [ group-number ]
View
Any view
Parameters
group-number: Group number of an address pool, in the range 0 to 319.
Description
Use the display nat address-group command to display the configuration of the
address pool.
Examples
# Display the configuration of the address pool.
<H3C> display nat address-group
NAT address-group information:
0
1
--2 entries found--

1.1.2 display nat aging-time

Syntax
display nat aging-time
: [address-group]
[description] teacher
[slot] 5
: [address-group]
Chapter 1 NAT Configuration Commands
1.1.1.1 ----
2.2.2.2 ----
1-1
1.1.1.2
2.2.2.3