Display Rip Interface - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches

10.0.0.0/8, cost 1, ClassfulSumm

10.0.0.0/24, cost 1, nexthop 10.0.0.1, Rip-interface

11.0.0.0/8, cost 1, ClassfulSumm

11.0.0.0/24, cost 1, nexthop 10.0.0.1, Imported

Table 2-2 Description on fields of the display rip database command

classful-summ

Rip-interface

2.1.6 display rip interface

display rip process-id interface [ interface-type interface-number ]

process-id: RIP process ID, in the range of 1 to 65535.

interface-type interface-number: Specifies an interface.

Use the display rip interface command to display the RIP interface information of the

RIP process.

If no interface is specified, information about all RIP interfaces of the RIP process is

# Display all the interface information of RIP process 1.

<Sysname> display rip 1 interface

Interface-name: Vlan-interface1

Destination address and subnet mask

Cost of the route

Indicates the route is a RIP summary route.

Address of the next hop

Routes learnt from a RIP–enabled interface

Routes redistributed from other routing protocols

Address/Mask:1.1.1.1/24

Split-horizon/Poison-reverse:on/off

Chapter 2 RIP Configuration Commands

MetricIn/Out:0/1

Input/Output:on/on

Version: RIPv1

Table of Contents