Display Bfd Interface - H3C S3610 Series Command Manual

Command Manual – BFD-GR
H3C S3610&S5510 Series Ethernet Switches
View
System view
Parameters
active: Uses the active mode. In the active mode, upon being enabled with BFD, an
interface actively transmits a BFD control packet to the remote device.
passive: Uses the passive mode. In the passive mode, an interface does not actively
transmit a BFD control packet to the remote end; it transmits a BFD control packet only
after receiving a BFD control packet from the remote end.
Description
Use the bfd session init-mode command to configure the mode for establishing a
BFD session.
Use the undo bfd session init-mode command to restore the default. By default, BFD
sessions are established in the active mode.
Examples
# Configure the session establishment mode as passive.
<Sysname> system-view
[Sysname] bfd session init-mode passive

1.1.8 display bfd interface

Syntax
display bfd interface [ verbose ]
View
Any view
Parameters
verbose: Displays detailed interface information.
Description
Use the display bfd interface command to display information about BFD-enabled
interfaces.
Besides the information displayed by the display bfd interface command, the display
bfd interface verbose command displays brief session information of the interfaces.
Examples
# Display information about BFD-enabled interfaces.
Chapter 1 BFD Configuration Commands
1-6