Select Control Mode - Lenze E84AVSC Operating Instructions Manual

5.3.1

Select control mode

Different control modes can be selected for every application in C00007. By selecting the
control mode you set the way the technology application should be controlled, e.g. via
terminals or via a fieldbus.
C00007
Control mode
Selection list
(Lenze setting printed in bold)
Pre-assignment of the digital terminals in the control modes "Terminals 0/2/11/16"
The four control modes "Terminals 0/2/11/16" only differ in the assignment of the digital
terminals to the control inputs of the application:
Control mode "Terminals 0":
Controller enable / reset error
Change of direction of rotation
Control mode "Terminals 11":
Controller enable / reset error
Change of direction of rotation
Motor potentiometer
from Firmware V06.00 - DMS 1.1 EN - 11/2011
0 Wiring has changed
10 Terminals 0
12 Terminals 2
14 Terminals 11
16 Terminal 16
20 Keypad
21 PC
30 CAN
40 MCI
External supply 24 V DC
X4
+
=
Fixed setpoint 1/3
Fixed setpoint 2/3
DC brake
DriveReady
External supply 24 V DC
X4
+ + +
=
DC brake active
Speed higher
Speed lower
DriveReady
L
8400 StateLine C | Operating instructions
General notes on applications
Info
This display appears if the FB interconnection has been
changed in the preconfigured I/O interconnection.
The technology application is controlled via the digital
and analog input terminals of the controller.
• For a short overview of the preconfigured terminal
assignment, see the following segment.
The technology application is controlled via the keypad.
See software manual.
Control mode "Terminals 2":
External supply 24 V DC
24E
24I
RFR Controller enable / reset error
Fixed setpoint 1/3
DI1
DI2 Fixed setpoint 2/3
DI3
Change of direction of rotation
DI4
DO1
GIO
Control mode "Terminals 16":
External supply 24 V DC
24E
24I
RFR Controller enable / reset error
Fixed setpoint 1/3
DI1
DI2 Fixed setpoint 2/3
Cw rotation quick stop
DI3
Ccw rotation quick stop
DI4
DO1
GIO
Before commissioning
X4
+ +
24E
=
24I
RFR
DI1
DI2
Quickstop
DI3
DI4
DriveReady DO1
GIO
X4
+ +
24E
=
24I
RFR
DI1
DI2
DI3
DI4
DO1
DriveReady
GIO
23