Ipv6 Classifier-List - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ipv6 classifier-list

Syntax
Release Information
Description
Options
1012
ipv6 classifier-list classifierName [ traffic-class trafficClassName ]
[ color { green | yellow | red } ] [ user-packet-class userPacketClassValue ]
[ source-route-class routeClassValue ] [ destination-route-class routeClassValue ]
[ local { true | false } ]
[ source-address ipv6Prefix | source-host ipv6Address ]
[ destination-address ipv6Prefix | destination-host ipv6Address ]
[ precedence precNum | dsfield dsFieldNum | tcfield tcFieldNum ]
[ protocol [ protocolQualifier ] ]
no ipv6 classifier-list classifierName [ classifierNumber ]
Command introduced before JunosE Release 7.1.0.
Creates or modifies an IPv6 classifier control list. The no version removes the classifier
control list.
classifierName—Name of the classifier control list entry
trafficClassName—Name of the traffic class to match
green—Matches packet color to green, indicating a low drop preference
yellow—Matches packet color to yellow, indicating a medium drop preference
red—Matches packet color to red, indicating a high drop preference
userPacketClassValue—User packet value to match
routeClassValue—Value of the source or destination route-class; in the range 0–255
local—Specifies traffic destined for this interface
true—Matches packets that are locally destined
false—Matches packets that are not locally destined
ipv6Prefix—Prefix that defines the IPv6 interface or network
ipv6Address—Base IPv6 address of the network route
precNum—Upper three bits of the traffic class byte; in the range 0–7
dsFieldNum—Upper six bits of the traffic class byte; in the range 0–63
tcFieldNum—Whole eight bits of the traffic class byte; in the range 0–255
protocol—Protocol type to match; tcp, udp, icmpv6, or protocol number in the range
0–255
protocolQualifier—Specifies the following protocol-specific parameters:
For TCP and UDP:
source-port or destination-port—Specifies that a source or destination port is
matched
Copyright © 2010, Juniper Networks, Inc.