Configure Kx Iii For Dual Lan Isolation Mode; Name Your Target Servers - LEGRAND Raritan Dominion KX III Quick Setup Manual

Configure KX III for Dual LAN Isolation Mode

Isolation mode allows you to access each LAN port independently
using different IP addresses.
Failover is not supported in this mode.
1. Select Device Settings > Network to open the Device Network
Settings page.
2. Set the IP Auto Configuration to None in the IPv4 section.
3. Ensure the "Enable Automatic Failover" checkbox is not
selected.
4. If needed, manually specify the network parameters by
entering the Default Gateway and then complete the steps that
follow.
5. Enter the IP address you want to use to connect to the KX III
LAN1. The default IP address is 192.168.0.192.
6. Enter the IPv4 Subnet Mask. The default subnet mask is
255.255.255.0.
7. In the LAN2 IPv4 section, set the IP Auto Configuration to None.
8. Enter the IP address you want to use to connect to the KX III
LAN2.
9. Enter the LAN2 IPv4 Default Gateway and Subnet Mask.
10. Complete the IPv6 sections, if applicable.
11. Select the IP Auto Configuration.
If None is selected, you must manually specify -
Dominion KX III Quick Setup Guide
QSG-DKX3-v3.6.9-0L-E  255-62-0003-00-RoHS
▪
Global/Unique IP Address - this is the IP address
assigned to KX III.
▪
Prefix Length - this is the number of bits used in the
IPv6 address.
▪
Gateway IP Address.
Select Router Discovery to locate a Global or Unique IPv6
address instead of a Link-Local subnet. Once located, the
address is automatically applied.
Note that the following additional, read-only information
appears in this section -
▪
Link-Local IP Address - this address is automatically
assigned to the device. It is used for neighbor discovery or
when no routers are present.
▪
Zone ID - Identifies the device the address is associated
with. Read-Only
12. Select "Use the Following DNS Server Addresses" and enter the
Primary DNS Server IP Address and Secondary DNS Server IP
Address. The secondary addresse is used if the primary DNS
server connection is lost due to an outage.
Note: "Obtain DNS Server Address Automatically" and
"Preferred DHCP Host Name" are only enabled when KX III is
configured in DHCP mode
13. When finished, click OK.
Your KX III device is now accessible via the LAN1 IP address and
the LAN2 IP address.

Name Your Target Servers

Connect all of the target servers if you have not already done so.
Select Device Settings > Port Configuration, then click the Port
Name of the target server you want to name.
1. Enter a name for the server up to 32 alphanumeric and special
characters. Click OK.
5