ADTRAN AOS Version R10.1.0 Command Reference Manual page 2232

Command Reference Guide
ip dhcp relay destination <ipv4 address>
Use the ip dhcp relay destination command to enable Dynamic Host Control Protocol (DHCP) for
Internet Protocol version 4 (IPv4) and to specify the IPv4 address for the DHCPv4 messages. Using the no
form of this command disables the relay functionality for the specified destination. When all destinations
are removed, DHCPv4 relay functionality is disabled on the interface.
Syntax Description
<ipv4 address>
Default Values
By default, no DHCP relay agent destinations are configured and the relay agent mode is disabled.
Command History
Release 18.2
Usage Examples
The following example enables DHCPv4 relay agent functionality and specifies the destination address as
192.33.4.251:
(config)#interface frame-relay 1.16
(config-fr 1.16)#ip dhcp relay destination 192.33.4.251
60000CRG0-35E
Specifies the IPv4 address for the DHCPv4 messages. IPv4 addresses
should be expressed in dotted decimal notation (for example, 10.10.10.1)..
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
2232