Nat Connection-Limit-Policy - H3C MSR 20-20 Command Reference Manual

Description
Example

nat connection-limit-policy

Syntax
View
Parameter
Description
Example
ftp: Supports FTP.
ils: Supports ILS.
nbt: Supports NBT.
pptp: Supports PPTP.
Use the command to enable NAT application layer gateway for the
nat alg
specified protocol.
Use the
undo nat alg
By default, NAT application layer gateway is enabled.
# Enable NAT application layer gateway for FTP.
<Sysname> system-view
[Sysname] nat alg ftp
nat connection-limit-policy policy-number
undo nat connection-limit-policy policy-number
System view
policy-number: Number of the connection-limit policy to be bound with the NAT
module. The value ranges from 0 to 19.
Use the
nat connection-limit-policy
policy with the NAT module.
Use the
undo nat connection-limit-policy
configuration.
Note that:
A NAT module can be bound with only one policy.
■
The globally configured connection limits are not effective unless a
■
connection-limit policy is bound to the NAT module.
If there are multiple NAT boards, the configuration applies to all the boards.
■
# Bind connection-limit policy 1 with the NAT module.
<Sysname> system-view
[Sysname]nat connection-limit-policy 1
# Remove the binding between connection-limit policy 1 and the NAT module.
command to disable NAT application layer gateway.
command to bind a connection-limit
command to remove the
2031