Rip Input; Rip Metricin - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches

2.1.19 rip input

Syntax
rip input
undo rip input
View
Interface view
Parameters
None
Description
Use the rip input command to enable the interface to receive RIP messages.
Use the undo rip input command to disable the interface from receiving RIP
messages.
By default, an interface is enabled to receive RIP messages.
Related commands: rip output.
Examples
# Disable VLAN-interface 10 from receiving RIP messages.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] undo rip input

2.1.20 rip metricin

Syntax
rip metricin value
undo rip metricin
View
Interface view
Parameters
value: Additional metric added to received routes, in the range of 0 to 16.
Description
Use the rip metricin command to add a metric to the received routes.
Use the undo rip metricin command to restore the default.
Chapter 2 RIP Configuration Commands
2-19