Sap-24Gbp; Oap Cards; Hims And Mims; Power Supplies - H3C SR6604 Installation Manual

SAP-24GBP

The SAP-24GBP has 24 high-performance fiber SFP ports that can be both routed and switched. One
two-color LED is available for each port to indicate their activity and link status. The module also has a
RUN LED to indicate the module operating status.
Figure 14 SAP-24GBP front panel
(1) SFP ports 0 to 23
(3) LEDs for SFP ports 0 to 23
(5) Captive screw

OAP cards

You can install an OAP card in a service module slot to provide value-added services such as security
and voice. An OAP card is OAA-enabled and has an independent operating system. You can follow the
OAA standard to customize your own OAP cards.
For the OAP cards available for the routers and their compatibility, see
compatibility
Interface Module Guide.

HIMs and MIMs

You can install HIMs to provide 10-Gbps service processing capability and install MIMs to provide
high-density narrowband aggregation. The HIMs and MIMs can offer a variety of interfaces, including
serial, Ethernet, POS, and E1.
The H3C SR6604 and SR6608 routers support the mix of HIMs and MIMs.
For the HIMs and MIMs available for the routers and their compatibility, see
compatibility

Power supplies

The H3C SR6604 and SR6608 routers can be DC-powered or AC-powered. You can install two power
supplies in your router, and they must be the same model.
The H3C SR6604 and SR6608 routers use hot swappable power supplies. You can install one power
supply, or for redundancy, two power supplies for your routers.

AC-input power supply

The AC input voltage range is 100 VAC to 240 VAC at 50 Hz to 60 Hz.
matrixes." For more information about the OAP cards, see the H3C SR6600 Routers
matrixes."
(2) SAP module status LED (RUN)
(4) Ejector levers
10
"Appendix B Hardware
"Appendix B Hardware