Rip Input - H3C s3600 series Command Manual

You can configure RIPv1 authentication mode in interface view, but the configuration will not take effect
because RIPv1 does not support authentication.
Examples
# Specify the interface VLAN-interface 10 to use the simple authentication with the authentication key
of aaa.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] rip authentication-mode simple aaa
# Specify VLAN-interface 10 to use the MD5 cipher text authentication, with the authentication key of
aaa and the packet format of rfc2453.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] rip authentication-mode md5 rfc2453 aaa

rip input

Syntax
rip input
undo rip input
View
Interface view
Parameters
None
Description
Use the rip input command to enable an interface to receive RIP packets.
Use the undo rip input command to disable an interface from receiving RIP packets.
By default, all interfaces, except loopback interfaces, can receive RIP packets.
Related commands: rip work.
Examples
# Disable the interface VLAN-interface 10 from receiving RIP packets.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname]interface Vlan-interface 10
[Sysname-Vlan-interface10] undo rip input
3-13