Stp Pathcost-Standard - H3C MSR 20-20 Command Reference Manual

616 C 38: MSTP C
HAPTER
Examples

stp pathcost-standard

Syntax
View
Parameters
Description
C
ONFIGURATION OMMANDS
By default, No Agreement Check is disabled.
n
The No Agreement Check feature can take effect only on the root port or
alternate port.
# Enable No Agreement Check on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] stp no-agreement-check
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
System view
dot1d-1998: The device calculates the default path cost for ports based on IEEE
802.1D-1998.
dot1t: The device calculates the default path cost for ports based on IEEE 802.1t.
legacy: The device calculates the default path cost for ports based on a private
standard.
Use the
stp pathcost-standard
use when calculating the default path cost of the link connected with the device
Use the undo stp pathcost-standard
of the calculation standard.
The default standard used by the device is legacy.
Note that if you change the standard that the device uses in calculating the default
path cost, the port path cost value set through the stp cost command will be out
of effect.
Table 110 Link speed vs. path cost
Link speed
0
10Mbps
command to specify a standard for the device to
Duplex state 802.1D-1998
- 65535
Single Port 100
Aggregated 100
Link 2 Ports
100
Aggregated
100
Link 3 Ports
Aggregated
Link 4 Ports
command to restore the default setting
IEEE 802.1t Private standard
200,000,000 200,000
2,000,000 2,000
1,000,000 1,800
666,666 1,600
500,000 1,400