Voice Analog Trunk Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
V A
OICE NALOG
Voice analog trunks are analog subscriber lines delivered by service providers that allow communication
devices to connect to the outside world. To configure analog trunks, you must first configure the foreign
exchange office (FXO) physical interface. By default, FXO interfaces are enabled, but their status must be
verified before creating an analog trunk. For more information on configuring and verifying FXO
interfaces, refer to the FXO Interface Command Set on page
Once the FXO interface is configured, a trunk account must be created for the analog trunk to make and
receive calls. When creating trunk accounts, you must assign an FXO port to the trunk, and make sure the
analog FXO settings (trunk number, supervision, etc.) match the parameters set by your service provider.
There are three main types of analog trunks supported by AOS. The first type is a dial pulse terminate
(DPT) analog trunk, the second type is a loop start (LS) analog trunk, and the third is a ground start (GS)
analog trunk. Configuration commands for all three analog trunk types are included in this section. For
more information about configuring analog trunks, refer to the NetVanta 7000 Series Trunk Accounts
configuration guide (article number 1541) available online at https://supportforums.adtran.com.
To enter the Voice Analog Trunk DPT Configuration mode, enter the following command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice trunk t01 type analog supervision dpt
(config-t01)#
To enter the Voice Analog Trunk LS Configuration mode, enter the following command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice trunk t01 type analog supervision loop-start
(config-t01)#
To enter the Voice Analog Trunk GS Configuration mode, enter the following command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice trunk t01 type analog supervision ground-start
(config-t01)#
Not all Voice Analog Trunk commands apply to all analog trunk types. Use the ? command
to display a list of valid commands.
60000CRG0-35E
T C
RUNK OMMAND
Copyright © 2012 ADTRAN, Inc.

Voice Analog Trunk Command Set

S
ET
1748.
3443