Table of Contents
Advertisement
Command Reference Guide
busy all
Use the busy all command to set all level zero digital signals (DS0s) to busy so that no calls are allowed
inbound or outbound. If any calls are active at the time this command is issued, the calls will stay active
until either party terminates the call. Once terminated, the DS0s are busied out. Use the no form of this
command to return to the default setting. Variations of this command include:
busy all
busy all now
Syntax Description
now
Default Values
No default values are necessary for this command.
Command History
Release 9.3
Release 11.1
Usage Examples
The following example sets all DS0s on trunk T01 to busy and terminates calls that are active at the time
the command is issued:
(config)#voice trunk t01 type analog supervision loop-start
(config-t01)#busy all now
60000CRG0-35E
Optional. Immediately terminates calls that are active at the time the
command is issued (for example, in the middle of a conversation).
Command was introduced.
Command was expanded to include the analog voice trunk.
Copyright © 2012 ADTRAN, Inc.
Voice Analog Trunk Command Set
3449
Advertisement
Table of Contents
