ADTRAN AOS Version R10.1.0 Command Reference Manual page 3049

Command Reference Guide
default-router
Use the default-router command to specify the default primary and secondary routers to use for the
Dynamic Host Configuration Protocol version 4 (DHCPv4) client. Use the no form of this command to
remove the configured router. Variations of this command include:
default-router <ipv4 address>
default-router <ipv4 address> <secondary>
Syntax Description
<ipv4 address>
<secondary>
Default Values
By default, there are no specified default routers.
Command History
Release 2.1
Functional Notes
When specifying a router to use as the primary/secondary preferred router, verify that the listed router is on
the same subnet as the DHCPv4 client. AOS allows a designation for two routers, listed in order of
precedence.
Usage Examples
The following example configures a default router with address 192.22.4.253 and a secondary router with
address 192.22.4.254:
(config)#ip dhcp pool MyPool
(config-dhcp)#default-router 192.22.4.253 192.22.4.254
60000CRG0-35E
Specifies the IPv4 address of the preferred router on the client's subnet.
Optional. Specifies the IPv4 address of the second preferred router on the
client's subnet.
IPv4 addresses should be expressed in dotted decimal notation (for
example, 10.10.10.1).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv4 Pool Command Set
3049