ADTRAN AOS Version R10.1.0 Command Reference Manual page 3268

Command Reference Guide
truncate-packet <value>
Use the truncate-packet command to specify the maximum number of bytes to be captured from each
packet when using packet capture. This command is primarily used for performance reasons. This
command allows you to specify that packets larger than the defined value are truncated. Use the no form of
this command to return to the truncated packet size default value.
Syntax Description
<value>
Default Values
By default, the truncated packet size is set to 0, which indicates that packets should not be truncated.
Command History
Release R10.1.0
Usage Examples
The following example enables packet truncating, and specifies that after 28 bytes the packet is truncated:
(config)#packet-capture 1CAPTURE standard
(config-packet-capture-1CAPTURE)#truncate-packet 28
60000CRG0-35E
Specifies the maximum number of captured bytes in a packet before the
packet is truncated. This value can be expressed in bytes, kilobytes (k or
K), or megabytes (m or M).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Packet Capture Command Set
3268