ADTRAN AOS Version R10.1.0 Command Reference Manual page 3242

Command Reference Guide
rtp delay-mode
Use the rtp delay-mode command to configure the Realtime Transport Protocol (RTP) jitter buffer mode
settings. RTP is used to prevent static on voice connections by enhancing the quality of the packet delivery.
Use the no form of this command to return to the default setting. Variations of this command include:
rtp delay-mode adaptive
rtp delay-mode fixed
Syntax Description
adaptive
fixed
Default Values
By default, the RTP delay mode is set to adaptive. This allows for minimal latency by adjusting the
average packet delay based on the conditions of the network.
Command History
Release 11.1
Release 15.1
Release A2
Usage Examples
The following example configures RTP delay mode as fixed on MGCP endpoint 1:
(config)#voice mgcp-endpoint 1
(config-mgcp-1)#rtp delay-mode fixed
60000CRG0-35E
Configures the RTP jitter buffer packet delay to adjust during a call based
on network conditions.
Configures the RTP jitter buffer packet delay to remain constant.
Command was introduced.
Command was added to the Voice Line Interface.
Command was added to the Media Gateway Control Protocol (MGCP)
endpoint configuration.
Copyright © 2012 ADTRAN, Inc.
MGCP Command Set
3242