Table of Contents
Advertisement
Command Reference Guide
permit mac <source> <destination>
Use the permit mac command to configure the medium access control (MAC) hardware access control list
(ACL) to permit specified frames to enter the system. Use the no form of this command to remove the
permit parameters from the ACL. Variations of this command include:
permit mac <source> <destination>
permit mac <source> <destination> log
Syntax Description
<source>
<destination>
log
Default Values
By default, all AOS security features are disabled, and there are no configured hardware ACLs.
Command History
Release 17.6
60000CRG0-35E
Specifies the source used for frame matching. Sources can be expressed in
one of three ways:
1. Using the keyword any to match any MAC address.
2. Using address <mac address> to specify a single host address. IP
addresses should be expressed in dotted decimal notation (for
example, 08:00:69:02:06:CB).
3. Using the <mac address> <wildcard mask> format to match all IP
addresses in a range. The wildcard mask corresponds to a range of IP
addresses (network) or a specific host. Wildcard masks are expressed
in dotted decimal notation (for example, 0.0.0.255).
Specifies the destination used for frame matching. Destinations can be
expressed in one of three ways:
1. Using the keyword any to match any MAC address.
2. Using address <mac address> to specify a single host address. IP
addresses should be expressed in dotted decimal notation (for
example, 08:00:69:02:06:CB).
3. Using the <mac address> <wildcard mask> format to match all IP
addresses in a range. The wildcard mask corresponds to a range of IP
addresses (network) or a specific host. Wildcard masks are expressed
in dotted decimal notation (for example, 0.0.0.255).
Optional. Enables logging of any frames that match the hardware ACL
entry.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Hardware ACLs and Hardware Access Maps
3119
Advertisement
Table of Contents
