ADTRAN AOS Version R10.1.0 Command Reference Manual page 3047

Command Reference Guide
client-identifier <identifier>
Use the client-identifier command to specify a unique identifier (in dotted hexadecimal notation) for a
Dynamic Host Configuration Protocol version 4 (DHCPv4) client. Use the no form of this command to
remove a configured client identifier.
Syntax Description
<identifier>
Default Values
No default values are necessary for this command.
Command History
Release 2.1
Functional Notes
DHCPv4 clients use client identifiers in place of hardware addresses. To create the client identifier, begin
with the two-digit numerical code representing the media type and append the client's medium access
control (MAC) address. For example, a Microsoft client with an Ethernet (01) MAC address
d2:17:04:91:11:50 uses a client identifier of 01:d2:17:04:91:11:50.
Usage Examples
The following example specifies the client identifier for a Microsoft client with an Ethernet MAC address of
d217.0491.1150:
(config)#ip dhcp pool Microsoft_Clients
(config-dhcp)#client-identifier 01:d2:17:04:91:11:50
60000CRG0-35E
Specifies a client identifier using 7 to 28 hexadecimal characters with colon
delimiters. Refer to the Functional Notes below for more information.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv4 Pool Command Set
3047