Dhcpv6 Server Pool Host Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
DHCP 6 S
V ERVER
In Dynamic Host Control Protocol version 6 (DHCPv6), you can create a DHCPv6 host entry within a
DHCPv6 server pool by issuing the host client-identifier command from the DHCPv6 Server Pool
Configuration mode. This command creates a host entry in the server pool and enters the DHCPv6 Server
Pool Host Configuration mode. From this mode, you can specify an Internet Protocol version 6 (IPv6)
address and additional host name bindings for a single DHCPv6 client.
To create a DHCPv6 host entry within a DHCPv6 server pool, enter the host client-identifier command
from the DHCPv6 Server Pool Configuration mode as follows:
(config)#ipv6 dhcp pool MYPOOL
(config-dhcpv6)#host client-identifier F2A4C9
(config-dhcpv6-host)#
For more information about configuring DHCPv6, and DHCPv6 server pools, refer to the configuration
guide Configuring DHCPv6 in AOS available online at
3527) and the DHCPv6 Pool Command Set on page 3067
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
All other commands for this command set are described in this section in alphabetical order.
address <ipv6 address> lifetime on page 3088
host client-identifier on page 3089
hostname on page 3090
60000CRG0-35E
P H C
OOL OST
Copyright © 2012 ADTRAN, Inc.

DHCPv6 Server Pool Host Command Set

S
OMMAND ET
http://supportforums.adtran.com
of this guide.
(article number
3087