ADTRAN AOS Version R10.1.0 Command Reference Manual page 3204

Command Reference Guide Mail Agent Command Set
capture commands
Use the capture commands command to specify the command output to capture and include in the body
of the email. Use the no form of this command to remove the specified commands.
Syntax Description
No subcommands.
Default Values
By default, no commands are specified.
Command History
Release 17.2 Command was introduced.
Functional Notes
The capture commands command specifies the command output to be captured by the mail agent. Show
and tcl commands can be captured. When the capture commands command is entered, each command
to be captured is specified with the do keyword followed by the command. The terminal configuration
mode is enabled by default for the capture commands command, making it necessary to use the keyword
do. List all commands to be sent in a single notification, followed by the exit keyword.
Usage Examples
The following example specifies that the mail agent myagent will capture the output from the show ip
route and show clock commands:
(config)#mail-client myagent
(config-mail-client-myagent)#capture commands
Enter the commands you wish to run, one line at a time.
Entries are run from the terminal configuration prompt.
For example, you must enter 'do show run' or 'int eth 0/1'.
When finished, type 'exit' on a new line to end.
#do show ip route
#do show clock
#exit
(config-mail-client-myagent)#
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 3204