ADTRAN AOS Version R10.1.0 Command Reference Manual page 3233

Command Reference Guide
codec-group <name>
Use the codec-group command to specify the coder-decoder (CODEC) list to be used by this account. Use
the no form of this command to remove the CODEC list from the account.
Syntax Description
<name>
Default Values
By default, no CODEC lists are assigned.
Command History
Release 9.3
Release 11.1
Release 15.1
Release A1
Release A2
Functional Notes
The codec-group command applies a previously configured CODEC list to an interface, voice trunk, or
voice account. These lists are lists of CODECs used by the interface, trunk, or account in call negotiation,
and are arranged in preferred order with the first listed CODEC being the most preferred.
CODEC lists are created using the codec command from the Voice CODEC List Configuration mode
prompt. For more information about creating CODEC lists, refer to the
on page 3803.
Usage Examples
The following example applies the CODEC list List1 to the MGCP endpoint 1:
(config)#voice mgcp-endpoint 1
(config-mgcp-1)#codec-group List1
60000CRG0-35E
Specifies the CODEC list to be used for this account.
Command was introduced.
Command was expanded to include the integrated services digital network
(ISDN) trunk.
Command was added to the Voice Line Configuration command set.
Command was included in the Voice Loopback Account Configuration
command set.
Command was added to the Media Gateway Control Protocol (MGCP)
Configuration command set.
Copyright © 2012 ADTRAN, Inc.
MGCP Command Set
Voice CODEC List Command Set
3233