ADTRAN AOS Version R10.1.0 Command Reference Manual page 3092

Adtran operating system (aos)
Table of Contents

Advertisement

Command Reference Guide
After entering the MD Configuration mode, you can access the MA Configuration mode, the MEP
Configuration mode, and the Interface Configuration mode. The following command set describes
commands common to all CFM Configuration modes, as well as those specific to maintenance association
(MA), MEP, or Interface configurations. For more information regarding Ethernet OAM CFM and its
operation on AOS products, refer to the Ethernet OAM CFM in AOS configuration guide available online
at
https://supportforums.adtran.com
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
exit on page 73
interface on page 74
The following commands are MD configuration commands:
association <name> on page 3093
remote-mep hold-time <minutes> on page 3094
The association <name> command, as described in the MD configuration command section, creates an
MA and enters the MA Configuration mode. The following commands are MA configuration commands:
ccm interval on page 3095
component <component> vlan on page 3096
mep-validation on page 3098
remote-mep <mep id> on page 3100
The component command, as described in the MA configuration command section, creates a component
and enters the Component Configuration mode. The following commands are component configuration
commands:
mp-sender-id on page 3101
Ethernet OAM CFM can also be configured at the interface level. CFM must be enabled and an MEP must
be created at the interface level using the commands
mep on page 1610
from the Ethernet or Ethernet subinterfaces. Once CFM is enabled and the MEP is
created at the interface level, the MEP can be configured using the following commands:
alarm-priority-level on page 3102
alarm timers <alarm time> <reset time> on page 3104
ccm-enabled on page 3105
mep-enabled on page 3106
priority <value> on page 3107
snmp-trap fault alarm on page 3108
60000CRG0-35E
(article number 3013).
ethernet-cfm down on page 1609
Copyright © 2012 ADTRAN, Inc.
Ethernet OAM CFM Command Set
and
ethernet-cfm
3092

Advertisement

Table of Contents
loading

Related Products for ADTRAN AOS Version R10.1.0

This manual is also suitable for:

Aos r10.1.0

Table of Contents