Dhcpv4 Pool Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
DHCP 4 P
V OOL
The Dynamic Host Configuration Protocol version 4 (DHCPv4) server pool is created using the ip dhcp
pool command from the Global Configuration mode prompt. This command creates the DHCPv4 server
pool and enters the pool's configuration mode. The server pool is used to define the information to be
assigned to clients by the DHCPv4 server. The pool chosen to serve a specific client's request is
determined by the current pool selection algorithm. To create a DHCPv4 server pool, and enter the pool's
configuration mode, enter the command as follows:
>enable
#configure terminal
(config)#ip dhcp pool MyPool
(config-dhcp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
bootfile <name> on page 3046
client-identifier <identifier> on page 3047
client-name <name> on page 3048
default-router on page 3049
dns-server on page 3050
domain-name <name> on page 3051
hardware-address on page 3052
host <ipv4 address> on page 3054
lease <days> on page 3055
nap on page 3056
netbios-name-server on page 3057
netbios-node-type on page 3058
network on page 3059
next-server <ipv4 address> on page 3060
next-server-file <name> on page 3061
ntp-server <ipv4 address> on page 3062
option on page 3063
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

DHCPv4 Pool Command Set

3044