ADTRAN AOS Version R10.1.0 Command Reference Manual page 3078

Command Reference Guide
ntp address <ipv6 address>
Use the ntp address command to specify the unicast Internet Protocol version 6 (IPv6) address, or a
multicast group address, of a Network Time Protocol (NTP) server to be supplied to requesting Dynamic
Host Control Protocol version 6 (DHCPv6) clients served by this DHCPv6 pool. Use the no form of this
command to remove the server address from the pool. If no NTP server address is specified when using the
no form of this command, all NTP server addresses are removed from the pool.
Syntax Description
<ipv6 address>
Default Values
By default, no NTP information is specified or sent to the DHCPv6 client.
Command History
Release 18.3
Functional Notes
Multiple NTP server addresses can be entered using multiple instances of this command. Each address is
added or deleted individually. Up to 50 addresses can be entered. These addresses are assigned in the
order they are entered. If the no version of this command is entered without specifying an address, all NTP
server addresses are removed from the pool.
Usage Examples
The following example adds an NTP server address to the DHCPv6 pool:
(config)#ipv6 dhcp pool MyPool
(config-dhcpv6)#ntp address 2001:DB8:1::1
60000CRG0-35E
Specifies the unicast or multicast IPv6 address of the NTP server to be
supplied to requesting DHCPv6 clients that use this DHCPv6 pool. IPv6
addresses should be expressed in colon hexadecimal format (X:X:X:X::X).
For example, 2001:DB8:1::1.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv6 Pool Command Set
3078