ADTRAN AOS Version R10.1.0 Command Reference Manual page 3034

Command Reference Guide
update-timer <value>
Use the update-timer command to set the value of the Routing Information Protocol (RIP) update interval
timer. The RIP update interval is the number of seconds that must elapse between RIP update packet
transmissions. Use the no form of this command to return to the default setting.
Syntax Description
<value>
Default Values
By default, this value is set at 30 seconds.
Command History
Release 11.1
Functional Notes
Note that the timeout-timer value cannot be set to a value less than the update-timer value. It is
recommended that the timeout-timer be set to a value that is three times the value of the update-timer.
(Refer to timeout-timer <value> on page 3033
Usage Examples
The following example sets the rate at which RIP update messages are transmitted from the router to
20 seconds.
(config)#router rip
(config-rip)#update-timer 20
60000CRG0-35E
Specifies the number of seconds allowed to elapse between RIP update
packet transmissions. Valid range is 5 to 4294967295 seconds.
Command was introduced.
for more information.)
Copyright © 2012 ADTRAN, Inc.
Router (RIP) Command Set
3034