ADTRAN AOS Version R10.1.0 Command Reference Manual page 2995

Command Reference Guide
area <area id> default-cost <value>
Use the area default-cost command to assign a cost of the default summary route sent into a stub area or
not-so-stubby-area (NSSA). Use the no form of this command to delete the assigned cost.
Syntax Description
<area id>
<value>
Default Values
By default, the summary route cost is set to 0. There is no default for the area ID.
Command History
Release 3.1
Usage Examples
The following example defines a default cost of 85 to a specific area:
(config)#router ospf
(config-ospf)#area 192.22.72.0 default-cost 85
60000CRG0-35E
Specifies the identifier for this area. Specifies as an integer (range is 0 to
4294967295) or an IP address. IP addresses should be expressed in dotted
decimal notation (for example, 10.10.10.1).
Specifies the default summary route cost. Range is 0 to 166777214.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Router (OSPF) Command Set
2995