ADTRAN AOS Version R10.1.0 Command Reference Manual page 2982

Command Reference Guide Network Monitor Track Command Set
snmp trap state-change
Use the snmp trap state-change command to enable the network monitor track to send a Simple Network
Management Protocol (SNMP) trap when a change in state occurs. Use the no form of this command to
disable the trap.
Syntax Description
No subcommands.
Default Values
By default, the state-change trap is disabled.
Command History
Release 18.1 Command was introduced.
Functional Notes
The network monitor track set of traps must also be enabled using the snmp-server enable traps track
command in the Global Configuration mode. Refer to snmp-server enable traps on page 1322 for more
information.
Additional configuration steps are necessary to configure SNMP traps for this feature to function. Refer to
the SNMP in AOS configuration guide available online at https://supportforums.adtran.com (article number
1134).
Usage Examples
The following example enables the snmp trap state-change for network monitoring:
(config)#track track1
(config-track-track1)#snmp trap state-change
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 2982