Voice Operator Ring Group Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
V O
OICE PERATOR
Voice operator ring groups are a subset of voice ring groups. Voice ring groups are groups of user accounts
that can be called in a coordinated way with a single extension, and voice operator ring groups are one of
these groups. Ring group members can log in when they want to receive calls from the group, and log out
when they do not want to receive group calls.
Operator ring groups ring all members of the group simultaneously, and contain a single voice mailbox for
the entire group. Operator ring groups can be configured to ring members by using a linear hunt method, in
which calls are distributed to members in the order in which they were added to the group; by using
uniform call distribution (UCD) method, in which calls are distributed to group members in the order in
which they were added to the group in a uniform, round-robin fashion; and by using an all ring method, in
which all members of the group are called and the first extension to pick up receives the call. Operator ring
groups can also be configured to display operator calling-party identification.
Operator ring groups are always tied to extension zero, and calls from the operator ring group have a
special ring cadence called a priority ring. A priority ring has two short rings, a long ring, and then silence.
All other settings for the operator ring group are similar to those of normal ring groups.
For more information on voice operator ring groups and voice ring groups in general, refer to the NetVanta
7000 Series Ring Groups and Operator Groups quick configuration guide (article number 1539) available
online at https://supportforums.adtran.com, or to the
To activate the Voice Operator Ring Group Configuration mode, enter the voice operator-group
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice operator-group
(config-operator-group)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
do on page 71
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
coverage on page 3386
did <number> on page 3388
email <address> on page 3389
email-secondary <address> on page 3390
60000CRG0-35E
R G C
ING ROUP
Voice Ring Group Command Set on page
Copyright © 2012 ADTRAN, Inc.

Voice Operator Ring Group Command Set

S
OMMAND ET
3407.
3384