Ike Policy Attributes Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
IKE P A
OLICY
To activate the Internet Key Exchange (IKE) Policy Attributes mode, enter the attribute command at the
IKE Policy prompt. For example:
>enable
#configure terminal
(config)#crypto ike policy 1
(config-ike)#attribute 10
(config-ike-attribute)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
authentication on page 3949
encryption on page 3950
group on page 3951
hash on page 3952
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 3953
lifetime <value> on page 3954
For virtual private network (VPN) configuration example scripts, refer to the VPN
configuration guide located on the AOS Documentation CD provided with your unit.
60000CRG0-35E
C
TTRIBUTES OMMAND
Copyright © 2012 ADTRAN, Inc.

IKE Policy Attributes Command Set

S
ET
3948