ADTRAN AOS Version R10.1.0 Command Reference Manual page 2962

Command Reference Guide
timeout <value>
Use the timeout command to specify the amount of time to wait for a test result before determining a
failure. Use the no form of this command to remove the timeout setting.
Syntax Description
<value>
Default Values
By default, the timeout is 2000 milliseconds, and 10000 milliseconds (10 seconds) for Transmission
Control Protocol (TCP) connect probes and 10000 milliseconds (10 seconds) for Hypertext Transfer
Protocol (HTTP) request probes.
Command History
Release 13.1
Usage Examples
The following example configures AOS to wait 90 milliseconds before determining a failure on probe1:
(config)#probe probe1 icmp-echo
(config-probe-probe1)#timeout 90
60000CRG0-35E
Specifies the timeout value in milliseconds. This value must be less than the
probe period value (refer to
1 to 900000 milliseconds.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Probe Command Set
dscp <value> on page 2947). Valid range is
2962