Table of Contents
Advertisement
Command Reference Guide
match ip address <name>
Use the match ip address command to configure the route map to route traffic based on the access control
list (ACL) name defined with the ip access-list command. Refer to
name> on page 984
for more information. Use the no form of this command to discontinue matching.
Syntax Description
<name>
Default Values
No default values are necessary for this command.
Command History
Release 10.1
Usage Examples
The following example instructs the route map named MYMAP to match the IP address ACL named
MYLIST:
(config)#route-map MYMAP permit 100
(config-route-map)#match ip address MYLIST
60000CRG0-35E
Specifies the name of the ACL to match.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Route Map Command Set
ip access-list standard <ipv4 acl
3305
Advertisement
Table of Contents
