ADTRAN AOS Version R10.1.0 Command Reference Manual page 3324

Command Reference Guide
set ip default next-hop <interface>
Use the set ip default next-hop command to set the next-hop IP address to the specified interface's
address for all routes serviced by the route map that do not have explicit routing information available. Use
the no form of this command to remove the configured default next hop.
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 11.1
Usage Examples
The following example sets the default next-hop interface to the ppp 1 interface:
(config)#route-map MYMAP permit 100
(config-route-map)#set ip default next-hop ppp 1
60000CRG0-35E
Specifies the default interface. Specify an interface in the format <interface
type [slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for a T1
interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a PPP
interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type set default
next-hop ? for a list of valid interface types.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Route Map Command Set
3324