Table of Contents
Advertisement
Command Reference Guide
snmp trap registration failures <value> interval <value>
Use the snmp trap registration command to specify that Simple Network Management Protocol (SNMP)
traps are enabled for the trunk, and that these traps are sent for Session Initiation Protocol (SIP) registration
events. In addition, this command specifies how many registration failures can occur before an SNMP trap
is sent, and at what interval the traps are sent. Use the no form of this command to disable SNMP traps for
the trunk.
Syntax Description
failures <value>
interval <value>
Default Values
By default, SNMP traps are disabled on the trunk.
Command History
Release A5.01
Usage Examples
The following example enables SNMP traps on the trunk, and specifies that traps are sent for every 3
registration failures and every 3600 seconds:
(config)#voice trunk t01 type sip
(config-t01)#snmp trap registration failures 3 interval 3600
60000CRG0-35E
Specifies the number of failures that occur before a trap is sent. Valid range
is 1 to 128 failures.
Specifies the time (in seconds) that elapses between traps. Valid range is
30 to 86400 seconds.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice SIP Trunk Command Set
3599
Advertisement
Table of Contents
