Router (Pim Sparse) Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
R (PIM S
OUTER
To activate the Router (Protocol-Independent Multicast (PIM) Sparse) Configuration mode, enter the
router pim-sparse command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router pim-sparse
(config-pim-sparse)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 3016
join-prune-msg-interval <value> on page 3017
rp-address <ip address> on page 3018
spt-threshold on page 3019
60000CRG0-35E
) C
PARSE OMMAND
Copyright © 2012 ADTRAN, Inc.

Router (PIM Sparse) Command Set

S
ET
3015