ADTRAN AOS Version R10.1.0 Command Reference Manual page 3061

Command Reference Guide
next-server-file <name>
Use the next-server-file command to specify the file name presented in the boot file name field in the
Bootstrap Protocol (BOOTP) header of the DHCPOFFER message. This file name is generally located on
the next-server, the address of which is specified by the server Internet Protocol version 4 (IPv4) address
(SIADDR) field presented in the BOOTP header. Use the no form of this command to remove a
configured next server file.
Syntax Description
<file name>
Default Values
By default, no next server file is configured.
Command History
Release 18.1
Functional Notes
This command specifies a different element of a DHCPOFFER message than that which is specified using
the bootfile command.
Usage Examples
The following example specifies test.cfg as the file presented in the BOOTP header:
(config)#ip dhcp pool MyPool
(config-dhcp)#next-server-file test.cfg
60000CRG0-35E
Specifies the name of the file presented in the BOOTP header.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv4 Pool Command Set
3061