ADTRAN AOS Version R10.1.0 Command Reference Manual page 3476

Command Reference Guide
rtp packet-delay
Use the rtp packet-delay command to configure the maximum Realtime Transport Protocol (RTP) packet
delays. This command is used to set the allowable limits of latency on the network. Use the no form of this
command to return to the default value. Variations of this command include:
rtp packet-delay fax <value>
rtp packet-delay maximum <value>
rtp packet-delay nominal <value>
Syntax Description
fax <value>
maximum <value>
nominal <value>
Default Values
By default, the RTP packet delay for fax is 300, maximum is 100, and nominal is 50.
Command History
Release 11.1
Usage Examples
The following example configures the RTP fax delay time on trunk T01 to 200 milliseconds:
(config)#voice trunk t01 type analog supervision loop-start
(config-t01)#rtp packet-delay fax 200
60000CRG0-35E
Sets the fax delay time value. Range is 0 to 500 milliseconds.
Sets the maximum delay time value in increments of 10 milliseconds.
Range is 40 to 320 milliseconds.
Sets the nominal delay time value in increments of 10 milliseconds. Range
is 10 to 240 milliseconds.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice Analog Trunk Command Set
3476