Network Monitor Probe Responder Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
N M
ETWORK ONITOR
This section explains the commands available for Network Monitoring Probe Responders. A probe
responder is the general term used for a variety of server applications that respond to the network monitor
probe types. The Two-Way Active Measurement Protocol (TWAMP) probe responder encompasses the
responder side of the TWAMP-Control protocol by responding to TWAMP-Control messages and acting as
a remote endpoint for test packets. The Internet Control Message Protocol (ICMP) timestamp probe
responder responds to ICMP timestamp request packets so that it can act as a remote endpoint for ICMP
timestamp probes. Commands common to all the probe responder types are identified in the following
section, as well as isolated commands that only apply to the specific probe responder types.
To activate the Network Monitor Probe Responder Configuration mode, enter the probe responder
command at the Global Configuration mode prompt followed by the probe type. Specify the probe
responder type of icmp-timestamp, twamp, and udp-echo. For example:
>enable
#configure terminal
(config)#probe responder twamp
(config-responder-twamp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 71
cross-connect on page 67 (applicable to the ICMP timestamp and UDP echo responders only)
exit on page 73
interface on page 74
The following commands are applicable to ICMP timestamp probe responder types and can be executed
after this command:
(config)#probe responder icmp-timestamp
access-class <name> in on page 2968
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2971
shutdown on page 2974
60000CRG0-35E

Network Monitor Probe Responder Command Set

P R
ROBE ESPONDER
Copyright © 2012 ADTRAN, Inc.
C S
OMMAND ET
2966