ADTRAN AOS Version R10.1.0 Command Reference Manual page 3266

Command Reference Guide
match list <ipv4 acl name>
Use the match list command to specify that the packet-capture uses an Internet Protocol version 4 (IPv4)
access control list (ACL) to limit the type of traffic that is captured. This command can also be used to
prevent feedback, if necessary, or to filter the type of traffic captured for other network management
reasons. Use the no form of this command to remove the ACL from the packet-capture configuration.
Syntax Description
<ipv4 acl name>
Default Values
By default, no ACL is configured or applied to packet-captures.
Command History
Release R10.1.0
Usage Examples
The following example applies the previously created IPv4 ACL PREVENTFEEDBACK to the
packet-capture:
(config)#packet-capture 1CAPTURE standard
(config-packet-capture-1CAPTURE)#match list PREVENTFEEDBACK
60000CRG0-35E
Specifies the name of a previously created IPv4 ACL to use to limit the
traffic captured. ACLs are created using the commands
extended <ipv4 acl name> on page 982
name> on page 984.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Packet Capture Command Set
ip access-list
or ip access-list standard <ipv4 acl
3266