Table of Contents
Advertisement
Command Reference Guide
busy t1 <slot/port> tdm-group <number>
Use the busy t1 tdm-group command to set a particular set of level zero digital signals (DS0s) (defined in
a time division multiplexing (TDM) group) to busy so that no calls are allowed inbound or outbound the
interface. If any calls are active at the time this command is issued, the calls will stay active until either
party terminates the call. Once terminated, the DS0s are set to busy. Use the no form of this command to
disable this feature. Variations of this command include:
busy t1 <slot/port> tdm-group <number>
busy t1 <slot/port> tdm-group <number> now
Syntax Description
<slot/port>
<number>
now
Default Values
No default values are necessary for this command.
Command History
Release 9.3
Usage Examples
The following example sets DS0s in TDM group 2 to busy and terminates calls that are active when the
command is issued:
(config)#voice trunk t01 type t1-rbs supervision wink role network
(config-t01)#busy t1 0/1 tdm-group 2 now
60000CRG0-35E
Specifies the slot/port for the T1.
Specifies the TDM group ID number.
Optional. Terminates calls that are active at the time the command is issued
(for example, in the middle of a conversation).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice T1 Trunk Command Set
3610
Advertisement
Table of Contents
